MIL-K-70493(AR)
4.6.2 ESS vibration. Conduct the vibration test with the keyboard positioned on an appropriate adapter affixed to a vibrating machine that is capable of providing the amplitudes and
frequencies specified in 3.3.3. Unless otherwise specified, the
test equipment shall be in accordance with the "Test Facilities" requirements of MIL-F-13926. The applied motion shall be applied
in two separate planes for the time period specified. Upon
completion of the vibration sweep the keyboard shall be removed
from the vibration adapter and shall be subjected to the tests in
4.6.4 and 4.6.5 inclusive. It shall meet the requirements of
3.2.1.1 and 3.2.1.3 inclusive.
4.6.3 Key closure. This test is to be conducted utilizing an ohm meter and appropriate spring scale. With the ohm meter attached to the key to be tested and P1-AS (GND), verify
continuity and measure (with the spring scale) the force required to reduce resistance to less than 7.5 ohms. The force, resistance, and continuity shall be as specified in 3.2.1.1.
4.6.4 Light emitting diodes (LEDs). Conduct this test by connecting one end of a 200 ohm plus or minus 5 percent 1\4 W resistor (4 total) to each of the 4 LED contacts listed in Table I. Connect the other end of the resistors to a 5.3 plus or minus
0.1 void DC power supply that is referenced to GND. The output
response shall be as specified in 3.2.1.2.
4.6.5 Electroluminescent backlight (ELB). Conduct this test
by connecting a 35 plus or minus 1 volt rms sine wave generator to P1-B11 with respect to P1-A11. The output response shall be as specified in 3.2.1.3.
4.6.6 Workmanship. The keyboard shall be subjected to a visual and tactile examination for evidence of faulty workmanship. The assembly shall conform to the requirements of
3.6.
4.7 Reliability testing. The requiremnt for reliability test approval and the responsibility (Government or contractor) for reliability testing shall be as specified in the contract. The sample for reliability test shall consist of 3 keyboards. The
samples shall be manufactured in the same manner, using the same materials equipment, processes, and procedures as will be used in the production of the balance of the contract quantity. All parts
and materials, including packaging and packing, shall be obtained from the same source of supply as will be used in the production of the balance of the contract quantity.
10
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business